car tools
- hammer:
- Originally employed as a weapon of war, the hammer nowadays is used as a
kind of divining rod to locate expensive car parts not far from the object we
are trying to hit.
- mechanic's knife:
- Used to open and slice through the contents of cardboard cartons delivered
to your front door; works particularly well on boxes containing convertible
tops or tonneau covers.
- electric hand drill:
- Normally used for spinning steel Pop rivets in their holes until you die of
old age, but it also works great for drilling rollbar mounting holes in the
floor of a sports car just above the brake line that goes to the rear
axle.
- pliers:
- Used to round off bolt heads.
- hacksaw:
- One of a family of cutting tools built on the Ouija board principle. It
transforms human energy into a crooked, unpredictable motion, and the more you
attempt to influence its course, the more dismal your future becomes.
- vise-grips:
- Used to round off bolt heads. If nothing else is available, they can also
be used to transfer intense welding heat to the palm of your hand.
- oxyacetylene torch:
- Used almost entirely for lighting those stale garage cigarettes you keep
hidden in the back of the Whitworth socket drawer (What wife would think to
look in there?) because you can never remember to buy lighter fluid for the
Zippo lighter you got from the PX at Fort Campbell.
- Zippo lighter:
- See oxyacetylene torch.
- Whitworth sockets:
- Once used for working on older British cars and motorcycles, they are now
used mainly for hiding six-month old Salems from the sort of person who would
throw them away for no good reason.
- drill press:
- A tall upright machine useful for suddenly snatching flat metal bar stock
out of your hands so that it smacks you in the chest and flings your beer
across the room, splattering it against the Rolling Stones poster over the
bench grinder.
- wire wheel:
- Cleans rust off old bolts and then throws them somewhere under the
workbench with the speed of light. Also removes fingerprint whorls and
hard-earned guitar calluses in about the time it takes you to say, "Django
Reinhardt".
- hydraulic floor jack:
- Used for lowering a Mustang to the ground after you have installed a set of
Ford Motorsports lowered road springs, trapping the jack handle firmly under
the front air dam.
- eight-foot long douglas fir 2x4:
- Used for levering a car upward off a hydraulic jack.
- tweezers:
- A tool for removing wood splinters.
- phone:
- Tool for calling your neighbor Chris to see if he has another hydraulic
floor jack.
- Snap-On gasket scraper:
- Theoretically useful as a sandwich tool for spreading mayonnaise; used
mainly for getting dog-doo off your boot.
- E-Z out bolt and stud extractor:
- A tool that snaps off in bolt holes and is ten times harder than any known
drill bit.
- timing light:
- A stroboscopic instrument for illuminating grease buildup on crankshaft
pulleys.
- two-ton hydraulic engine hoist:
- A handy tool for testing the tensile strength of ground straps and
hydraulic clutch lines you may have forgotten to disconnect.
- Craftsman 1/2 x 16-inch screwdriver:
- A large motor mount prying tool that inexplicably has an accurately
machined screwdriver tip on the end without the handle.
- battery electrolyte tester:
- A handy tool for transferring sulfuric acid from a car battery to the
inside of your toolbox after determining that your battery is dead as a
doornail, just as you thought.
- aviation metal snips:
- See hacksaw.
- trouble light:
- The mechanic's own tanning booth. Sometimes called a drop light, it is a
good source of vitamin D, "the sunshine vitamin", which is not otherwise found
under cars at night. Health benefits aside, its main purpose is to consume
40-watt light bulbs at about the same rate that 105-mm howitzer shells might be
used during, say, the first few hours of the Battle of the Bulge. More often
dark than light, its name is somewhat misleading.
- Phillips screwdriver:
- Normally used to stab the lids of old-style paper-and-tin oil cans and
splash oil on your shirt; can also be used, as the name implies, to round-out
Phillips screw heads.
- air compressor:
- A machine that takes energy produced in a coal-burning power plant 200
miles away and transforms it into compressed air that travels by hose to a
Chicago Pneumatic impact wrench that grips rusty suspension bolts last
tightened 40 years ago by someone in Abingdon, Oxfordshire, and rounds them
off.